Suzuki GSX-R750 Service Manual page 581

13) Install the clutch push piece (13), bearing (14) and
thrust washer (15) to the countershaft.
NOTE
Thrust washer (15) is located between the
pressure plate and bearing (14).
13
14) Install the spring washer seat (16) and spring washer
(17) onto the clutch sleeve hub correctly.
16
15) Insert the clutch drive plates and driven plate one by
one into the clutch sleeve hub in the prescribed
order.
NOTE
Insert the outermost No. 3 drive plate claws
"A" to the other slits "B" of clutch housing as
shown in the figure.
"B"
"A"
15
I837H1530026-01
17
I837H1530028-01
I837H1530027-01
19
18
18. No. 2 drive plate
19. No. 1 drive plate
20. No. 3 drive plate
21. No. 1 driven plate (6 – 8 pcs.)
: The No. 1 and No. 2 driven plates are 8 in total.
22. No. 2 driven plate (0 – 2 pcs.)
: The No. 1 and No. 2 driven plates are 8 in total.
"C": Direction of outside
NOTE
For drive plate
Three kinds of the drive plate (No. 1, No. 2
and No. 3) are equipped in the clutch system,
they can be distinguished by the inside
diameter and clutch facing "D".
"D": Clutch facing
: No. 1 and No. 2 drive plates resemble each other very closely in
external appearance. Make sure to check the numbers of clutch
facing, before installing them.
Drive plate I.D.
No. 1 111 mm (4.4 in)
No. 2 118 mm (4.6 in)
No. 3 111 mm (4.4 in)
NOTE
Two kinds of the driven plate (No. 1 and No.
2) are equipped in the clutch system, they
can be distinguished by the thickness.
The No. 1 and No. 2 driven plates are 8 pcs. in
total.
6 – 8 pcs. of No. 1 driven plates are used with
0 – 2 pc(-s). of No. 2 driven plate(-s) as a set.
The driven plate No. 2 should be installed
pressure plate side.
Driven plate
No. 1
No. 2
Clutch: 5C-9
20
"C"
21 21 22 /
I837H1530029-01
"D"
I718H1530055-01
Clutch facing "D"
48 pcs.
36 pcs.
36 pcs.
Thickness
2.0 mm (0.08 in)
1.6 mm (0.06 in)