Suzuki GSX-R750 Service Manual page 229

EVAP System Purge Control Solenoid Valve
Removal
1) Lift and support the fuel tank with the prop stay.
Refer to "Fuel Tank Removal and Installation in
Section 1G (Page 1G-9)".
2) Disconnect the coupler (1) and purge hoses (2).
3) Remove the EVAP system purge control solenoid
valve (3) with the bracket.
1
4) Remove the bracket from the EVAP system purge
control solenoid valve.
Installation
Install the EVAP system purge control solenoid valve in
the reverse order of removal. Pay attention to the
following point:
• Tighten the EVAP system purge control solenoid valve
mounting nut to the specified torque.
Tightening torque
EVAP system purge control solenoid valve
mounting nut (a): 6.5 N·m (0.65 kgf-m, 4.5 lb-ft)
(a)
3
2
I837H1120026-02
I837H1120028-02
I837H1120052-01
Emission Control Devices:
Fuel Shut-off Valve
Removal
1) Remove the front seat. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
11)".
2) Remove the battery (1). Refer to "Battery Removal
and Installation in Section 1J (Page 1J-13)".
3) Remove the ECM (2). Refer to "ECM Removal and
Installation in Section 1C (Page 1C-1)".
1
4) Remove the frame cover assembly. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-11)".
5) Remove the starter relay (3).
6) Disconnect the EVAP hoses from the clamp.
7) Disconnect the license plate light coupler (4).
8) Release the license plate light lead wire from the
clamp (5).
5
1B-13
2
I837H1120030-01
3
I837H1120031-01
4
I837H1120033-02