2C-14 Rear Suspension:
Installation
CAUTION
!
The removed bearings must be replaced with
new ones.
1) Install the center spacer.
2) Press the bearings into the swingarm pivot with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09941–34513 (Steering race installer)
3) Apply grease to the bearings.
GREASE A or equivalent)
4) Install the swingarm. Refer to "Swingarm Removal
and Installation (Page 2C-10)".
(A)
I837H1230052-01
: Grease 99000–25010 (SUZUKI SUPER
I837H1230053-01