3A-8 Drive Chain / Drive Train / Drive Shaft:
4) Tighten the pressure bolt [A] (3) with the bar.
8
6
5) Turn in the pressure bolt [B] (4) with the bar (5) and
force out the drive chain joint pin (9).
CAUTION
!
Continue turning in the pressure bolt [B] (4)
until the joint pin should been completely
pushed out of the chain.
NOTE
After the joint pin (9) is removed, loosen the
pressure bolt [B] (4) and then pressure bolt
[A] (3).
6) Remove the joint pin (9) of the other side of joint
plate.
CAUTION
!
Never reuse joint pins, O-rings and plates.
6
9
3
I837H1310027-02
4
5
I649G1310027-02
7
3
4
I837H1310028-02
Drive Chain Connecting
WARNING
!
Do not use joint clip type of drive chain. The
joint clip may have a chance to drop which
may cause severe damage to motorcycle and
severe injury.
Joint plate installation
1) Set up the special tool as shown in the figure.
(C520)
3
4
5
1. Tool body
2. Grip handle
3. Joint plate holder (Engraved mark "C520")
4. Wedge holder & wedge pin
5. Adjuster bolt (Without hole)
6. Pressure bolt [A]
7. Bar
2) Apply grease to the joint pins (8), O-rings (9) and
plates (10).
CAUTION
!
Replace the joint pins (8), O-rings (9) and
plates (10) with new ones.
3) Connect both ends of the drive chain with the joint
pins (8) inserted from the wheel side "A" as installed
on the motorcycle.
Joint set part number
RK: 27620 – 33E40
"A"
8
9
9
6
1
2
7
I837H1310025-01
8
9
9
10
I837H1310029-01