Rear Brake Caliper Parts Inspection - Suzuki GSX-R750 Service Manual

4C-5 Rear Brakes:
• Install the piston seal (1) as shown in the figure.
2
1
• Apply grease to the inside of the rubber boot.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
• Set the rubber boot (3) to the caliper.
• Install the spacer (4) into the rubber boot.
• Tighten the sliding pin (5) and apply grease to the
sliding pin.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
Tightening torque
Rear brake caliper sliding pin (a): 33 N·m (3.3 kgf-
m, 24.0 lb-ft)
• Set the rubber boot onto the brake caliper and sliding
pin.
I649G1420013-02
4
3
I837H1430013-01
5
(a)
I837H1430014-01
• Install the brake caliper to its bracket.

Rear Brake Caliper Parts Inspection

Refer to "Rear Brake Caliper Disassembly and
Assembly (Page 4C-4)".
Brake Caliper Cylinder
Inspect the brake caliper cylinder wall for nicks,
scratches or other damage. If any damage is found,
replace the caliper with a new one.
Brake Caliper Piston
Inspect the brake caliper piston surface for any
scratches or other damage. If any damage is found,
replace the piston with a new one.
I837H1430020-01
B838H24306006
I837H1430015-01
I837H1430021-01