Oil Pressure Regulator / Oil Strainer Inspection - Suzuki GSX-R750 Service Manual

• Install the oil pressure regulator (1) and oil strainer (2).
NOTE
When installing the oil strainer, fit the
concave part "A" of the oil strainer onto the
convex part "B" of the crankcase.
1
"A"
2
• Tighten the oil pan bolts diagonally.
CAUTION
!
• Use the new oil pan gasket to prevent oil
leakage.
• Fit the new gasket washer to the oil pan
bolt "C" to prevent oil leakage.
NOTE
• Apply a small quantity of thread lock to the
plate bolts "D".
• Fit the clamp to the bolt "E".
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Remount the engine assembly. Refer to "Engine
Assembly Installation in Section 1D (Page 1D-23)".
I837H1150008-01

Oil Pressure Regulator / Oil Strainer Inspection

Refer to "Oil Pan / Oil Strainer / Oil Pressure Regulator
Removal and Installation (Page 1E-6)".
Oil Pressure Regulator
"B"
Inspect the operation of the oil pressure regulator by
pushing on the piston with a proper bar.
If the piston does not operate, replace the oil pressure
regulator with a new one.
I837H1150009-01
Oil Strainer
Clean the oil strainer if necessary.
Inspect the oil strainer body for damage. If necessary,
replace it with a new one.
Engine Lubrication System:
: Thread lock cement 99000–32030
"D"
"C"
1E-7
"E"
I837H1150010-03
B838H21506004
I837H1150011-01
I837H1150012-01