Suzuki GSX-R750 Service Manual page 303

3) Set the crankshaft to the conrods and upper
crankcase.
4) Apply engine oil to each crank pin and bearing
surface.
CAUTION
!
Be sure to clean the conrod big end.
5) When fitting the conrod cap, make sure that I.D.
code "A" on each conrod faces intake side.
6) Apply engine oil to the conrod cap bolts.
I838H1140036-01
I838H1140037-01
"A"
I838H1140038-01
7) Tighten the conrod cap bolt by using a 10 mm, 12
point socket wrench in the following two steps.
Tightening torque
Conrod cap bolt: 15 N⋅m (1.5 kgf-m, 11.0 lb-ft)
then turn in 1/4 (90°) turn
" a "
"a": 90°
8) Apply engine oil to the conrod big end side surfaces.
9) Check the conrod movement for smooth turning.
10) Apply engine oil to each crankshaft journal.
Engine Mechanical: 1D-59
I838H1140039-01
I837H1140134-01
I838H1140040-01