Installation
When installing the bearings to the crankcases, be sure
to install the tab "A" first, and then press in the other
opposite side of the bearing.
NOTE
Inspect and select the balancer shaft journal
bearing if necessary. Refer to "Balancer Shaft
Journal Bearing Inspection and Selection
(Page 1D-75)".
"A"
Balancer Shaft Journal Bearing Inspection and
Selection
Refer to "Engine Bottom Side Disassembly (Page 1D-
47)".
Refer to "Engine Bottom Side Assembly (Page 1D-55)".
"A"
I838H1140058-01
I838H1140059-01
B838H21406039
Inspection
Inspect the bearing surfaces for any signs of fusion,
pitting, burn or flaws. If any, replace them with a
specified set of bearings.
Selection
1) Place the plastigauge axially along the balancer
shaft journal as shown.
Special tool
(A): 09900–22301 (Plastigauge (0.025 –
0.076 mm))
CAUTION
!
Never rotate the balancer shaft when a piece
of plastigauge is installed.
(A)
Engine Mechanical:
1D-75
I838H1140060-01
I838H1140061-01
I838H1140062-01