Suzuki GSX-R750 Service Manual page 308

1D-64 Engine Mechanical:
• Tighten the oil pan bolts diagonally to the specified
torque.
NOTE
• Fit the new gasket washer to the oil pan
bolt "A".
• Apply thread lock to the oil pan bolts "B"
and plate bolts "C".
• Fit the clamp to the oil pan bolt "D".
Tightening torque
Oil pan bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
"C"
"A"
Oil Cooler
• Apply grease to the O-ring (1).
CAUTION
!
Use a new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply thread lock to the oil cooler bolts (2) and tighten
them to the specified torque.
NOTE
Fit the clamp to the oil cooler bolt "A".
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Oil cooler mounting bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
1
3
"D"
"B"
2
I837H1140151-04
2
(a)
"A"
2
(a)
I837H1140152-03
Oil Filter
• Install the oil filter with the special tool. Refer to
"Engine Oil and Filter Replacement in Section 0B
(Page 0B-10)".
Special tool
(A): 09915–40610 (Oil filter wrench)
Oil Pressure Switch
• Apply bond to the thread part of oil pressure switch
and tighten oil pressure switch to the specified torque.
NOTE
Be careful not to apply bond to the hole of
thread end.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
Tightening torque
Oil pressure switch: 14 N·m (1.4 kgf-m, 10.0 lb-ft)
(A)
I837H1140153-01
I718H1140233-01