5C-2 Clutch:
Clutch Lever Position Switch Inspection
Inspect the clutch lever position switch in the following
procedures:
1) Disconnect the clutch lever position switch lead
wires (1).
2) Inspect the clutch lever position switch for continuity
with the tester.
If any abnormality is found, replace the switch with a
new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
)
Clutch lever position switch
Color
Terminal (B/Y)
Position
FREE
3) Connect the clutch lever position switch lead wires.
Repair Instructions
B838H25306001
1
I837H1530048-01
Terminal (B/W)
I649G1530004-03
Clutch Cable Inspection
Refer to "Clutch Cable Play Inspection and Adjustment
in Section 0B (Page 0B-14)".
Clutch Cable Removal and Installation
Removal
1) Remove the right under cowling. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-11)".
2) Disconnect the clutch cable from the clutch lever.
Refer to "Handlebar Removal and Installation in
Section 6B (Page 6B-2)".
3) Remove the clutch cable as shown in the throttle
cable routing diagram. Refer to "Throttle Cable
Routing Diagram in Section 1D (Page 1D-2)".
Installation
1) Install the clutch cable as shown in the throttle cable
routing diagram. Refer to "Throttle Cable Routing
Diagram in Section 1D (Page 1D-2)".
2) Reinstall the removed parts.
B838H25306002
B838H25306003