Suzuki GSX-R750 Service Manual page 582

5C-10 Clutch:
16) Install the pressure plate (23).
NOTE
When install the pressure plate, fit the
convex part "E" of the pressure plate onto
the concave part "F" of the clutch sleeve hub.
23
"E"
17) Install the clutch springs and bolts.
18) Tighten the clutch spring set bolts to the specified
torque.
Tightening torque
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-
ft)
NOTE
Tighten the clutch spring set bolt diagonally.
19) Loosen the lock nut (24) and turn in the release
screw (25) to feel resistance.
20) From that position, turn out the release screw (25) 1/
2 turn and tighten the lock nut (24) securely by
holding the release screw (25).
"F"
I837H1530030-03
I837H1530031-02
24
25
I837H1530032-02
21) Apply a bond lightly to the mating surfaces at the
parting line between the upper and lower crankcase
as shown in the figure.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
22) Install the dowel pins and gasket (26).
CAUTION
!
Use the new gasket to prevent oil leakage.
23) Apply a bond lightly to the CKP sensor grommet.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
I837H1530033-04
26
I837H1530034-01
I837H1530035-01