Setting The Atc Timers - Edge-Core ES3528MV2 Management Manual

| Congestion Control
C 9
HAPTER
Automatic Traffic Control
S
ETTING THE
ATC T
IMERS
Use the Traffic > Auto Traffic Control (Configure Global) page to set the
time at which to apply the control response after ingress traffic has
exceeded the upper threshold, and the time at which to release the control
response after ingress traffic has fallen beneath the lower threshold.
CLI R
EFERENCES
"auto-traffic-control apply-timer" on page 1034
◆
"auto-traffic-control release-timer" on page 1034
◆
C U
OMMAND SAGE
After the apply timer expires, the settings in the Traffic > Automatic
◆
Traffic Control (Configure Interface) page are used to determine if a
control action will be triggered (as configured under the Action field) or
a trap message sent (as configured under the Trap Storm Fire field).
The release timer only applies to a Rate Control response set in the
◆
Action field of the ATC (Interface Configuration) page. When a port has
been shut down by a control response, it must be manually re-enabled
using the Manual Control Release (see
P
ARAMETERS
These parameters are displayed in the web interface:
Broadcast Apply Timer – The interval after the upper threshold has
◆
been exceeded at which to apply the control response to broadcast
storms. (Range: 1-300 seconds; Default: 300 seconds)
Broadcast Release Timer – The time at which to release the control
◆
response after ingress traffic has fallen beneath the lower threshold for
broadcast storms. (Range: 1-900 seconds; Default: 900 seconds)
Multicast Apply Timer – The interval after the upper threshold has
◆
been exceeded at which to apply the control response to multicast
storms. (Range: 1-300 seconds; Default: 300 seconds)
Multicast Release Timer – The time at which to release the control
◆
response after ingress traffic has fallen beneath the lower threshold for
multicast storms. (Range: 1-900 seconds; Default: 900 seconds)
W I
EB NTERFACE
To configure the response timers for automatic storm control:
Click Traffic, Automatic Storm Control.
1.
Select Configure Global from the Step field.
2.
Set the apply and release timers for broadcast and multicast storms.
3.
Click Apply.
4.
– 266 –
page 267).