System Defaults; Table 2: System Defaults - Edge-Core ES3528MV2 Management Manual

L L
INK AYER
D P
ISCOVERY ROTOCOL
S D
YSTEM EFAULTS
LLDP is used to discover basic information about neighboring devices
within the local broadcast domain. LLDP is a Layer 2 protocol that
advertises information about the sending device and collects information
gathered from neighboring network nodes it discovers.
Advertised information is represented in Type Length Value (TLV) format
according to the IEEE 802.1ab standard, and can include details such as
device identification, capabilities and configuration settings. Media
Endpoint Discovery (LLDP-MED) is an extension of LLDP intended for
managing endpoint devices such as Voice over IP phones and network
switches. The LLDP-MED TLVs advertise information such as network
policy, power, inventory, and device location details. The LLDP and LLDP-
MED information can be used by SNMP applications to simplify
troubleshooting, enhance network management, and maintain an accurate
network topology.
The switch's system defaults are provided in the configuration file
"Factory_Default_Config.cfg." To reset the switch defaults, this file should
be set as the startup configuration file.
The following table lists some of the basic system defaults.

Table 2: System Defaults

Function Parameter
Console Port Connection Baud Rate
Data bits
Stop bits
Parity
Local Console Timeout
Authentication Privileged Exec Level
Normal Exec Level
Enable Privileged Exec from
Normal Exec Level
RADIUS Authentication
TACACS+ Authentication
802.1X Port Authentication
MAC Authentication
HTTPS
SSH
Port Security
– 75 –
| Introduction
C 1
HAPTER

System Defaults

Default
115200 bps
8
1
none
600 seconds
Username "admin"
Password "admin"
Username "guest"
Password "guest"
Password "super"
Disabled
Disabled
Disabled
Disabled
Enabled
Disabled
Disabled