Configuring Voip Traffic Ports - Edge-Core ES3528MV2 Management Manual

C V IP T
ONFIGURING O
P
RAFFIC ORTS
Use the Traffic > VoIP (Configure Interface) page to configure ports for
VoIP traffic, you need to set the mode (Auto or Manual), specify the
discovery method to use, and set the traffic priority. You can also enable
security filtering to ensure that only VoIP traffic is forwarded on the Voice
VLAN.
CLI R
EFERENCES
"Configuring Voice VLANs" on page 1161
◆
C U
OMMAND SAGE
All ports are set to VLAN hybrid mode by default. Prior to enabling VoIP for
a port (by setting the VoIP mode to Auto or Manual as described below),
first ensure that VLAN membership is not set to access mode (see
Static Members to VLANs" on page
P
ARAMETERS
These parameters are displayed:
Mode – Specifies if the port will be added to the Voice VLAN when VoIP
◆
traffic is detected. (Default: None)
None – The Voice VLAN feature is disabled on the port. The port will
■
not detect VoIP traffic or be added to the Voice VLAN.
Auto – The port will be added as a tagged member to the Voice
■
VLAN when VoIP traffic is detected on the port. You must select a
method for detecting VoIP traffic, either OUI or 802.1AB (LLDP).
When OUI is selected, be sure to configure the MAC address ranges
in the Telephony OUI list.
Manual – The Voice VLAN feature is enabled on the port, but the
■
port must be manually added to the Voice VLAN.
Security – Enables security filtering that discards any non-VoIP
◆
packets received on the port that are tagged with the voice VLAN ID.
VoIP traffic is identified by source MAC addresses configured in the
Telephony OUI list, or through LLDP that discovers VoIP devices
attached to the switch. Packets received from non-VoIP sources are
dropped. (Default: Disabled)
Discovery Protocol – Selects a method to use for detecting VoIP
◆
traffic on the port. (Default: OUI)
OUI – Traffic from VoIP devices is detected by the Organizationally
■
Unique Identifier (OUI) of the source MAC address. OUI numbers
are assigned to vendors and form the first three octets of a device
MAC address. MAC address OUI numbers must be configured in the
Telephony OUI list so that the switch recognizes the traffic as being
from a VoIP device.
– 305 –
| VoIP Traffic Configuration
C 12
HAPTER

Configuring VoIP Traffic Ports

198).
"Adding