Edge-Core ES3528MV2 Management Manual page 94

| Initial Switch Configuration
C 2
HAPTER
Managing System Files
contain slashes (\ or /), and the leading letter of the file name must not be
a period (.). (Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
There can be more than one user-defined configuration file saved in the
switch's flash memory, but only one is designated as the "startup" file that
is loaded when the switch boots. The copy running-config startup-
config command always sets the new file as the startup file. To select a
previously saved configuration file, use the boot system
config:<filename> command.
The maximum number of saved configuration files depends on available
flash memory. The amount of available flash memory can be checked by
using the dir command.
To save the current configuration settings, enter the following command:
From the Privileged Exec mode prompt, type "copy running-config
1.
startup-config" and press <Enter>.
Enter the name of the start-up file. Press <Enter>.
2.
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#
To restore configuration settings from a backup server, enter the following
command:
From the Privileged Exec mode prompt, type "copy tftp startup-config"
1.
and press <Enter>.
Enter the address of the TFTP server. Press <Enter>.
2.
Enter the name of the startup file stored on the server. Press <Enter>.
3.
Enter the name for the startup file on the switch. Press <Enter>.
4.
Console#copy file startup-config
Console#copy tftp startup-config
TFTP server IP address: 192.168.0.4
Source configuration file name: startup-rd.cfg
Startup configuration file name [startup1.cfg]:
Success.
Console#
– 94 –