Displaying Lacp Port Counters; Table 8: Lacp Port Counters - Edge-Core ES3528MV2 Management Manual

Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show
D LACP
ISPLAYING
Information - Counters) page to display statistics for LACP protocol
P C
ORT OUNTERS
messages.
CLI R
◆
P
ARAMETERS
These parameters are displayed:

Table 8: LACP Port Counters

Parameter
LACPDUs Sent
LACPDUs Received
Marker Sent
Marker Received
Marker Unknown Pkts
Marker Illegal Pkts
W
EB
To display LACP port counters:
1.
2.
3.
4.
5.
EFERENCES
"show lacp" on page 1012
Description
Number of valid LACPDUs transmitted from this channel group.
Number of valid LACPDUs received on this channel group.
Number of valid Marker PDUs transmitted from this channel
group.
Number of valid Marker PDUs received by this channel group.
Number of frames received that either (1) Carry the Slow
Protocols Ethernet Type value, but contain an unknown PDU, or
(2) are addressed to the Slow Protocols group MAC Address, but
do not carry the Slow Protocols Ethernet Type.
Number of frames that carry the Slow Protocols Ethernet Type
value, but contain a badly formed PDU or an illegal value of
Protocol Subtype.
I
NTERFACE
Click Interface, Trunk, Dynamic.
Select Configure Aggregation Port from the Step list.
Select Show Information from the Action list.
Click Counters.
Select a group member from the Port list.
– 179 –
| Interface Configuration
C 5
HAPTER
Trunk Configuration