Nmea Display Page; Changing The Nmea - Standard Horizon CP500 Owner's Manual

From this page it is possible to activate the GPS Setup menu following this procedure:
1. Press [MENU], move the ShuttlePoint knob to enter GPS STATUS page and press
[ENT].
2. Press and hold [ENT]. The GPS Setup menu appears on the screen. See the following
table:
Restart GPS
Navigation Speed
Speed Filter
Differential Correction Source : Allows setting what kind of Differential Correction will be used by the GPS between
3. Move the ShuttlePoint knob to highlight the preferred item and press [ENT].
4. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the menu disappears.
12.6

NMEA DISPLAY PAGE

The GPS Chart Plotter is capable of displaying information in the customizable data
windows from external NMEA-0183 devices. Depth Sounder, Speed Log with Temp, Wind
Speed and Direction, Flux Gate Compass, and GPS information can be shown in any of the
boxes. The default NMEA Display shows 3 windows. When going to a Destination, this
screen is useful to navigate as to get to the destination keep the Course Over Ground (COG)
and Bearing (BRG) figures the same.
The NMEA sentences read from external devices are: BWC, DSC, DSE, GGA, GLL, GSA,
GSV, HDG, HDM, HDT, RMC, VHW, VTG, DPT, DBT, MTW, VWR, VWT, TLL, WPL, RTE.
12.6.0 Changing the NMEA Page Windows
1. Press [MENU], move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT].
CP500
: Restarts all GPS processes. Once executed, the message "Done" is shown.
: Allows setting the Navigation Speed among Low and High. The default setting is High.
: Allows to resolve erratic speed readings in rough seas. Available values are Off, Low,
Medium, High. The default setting is Off.
WAAS-EGNOS and none. The default setting is WAAS-EGNOS.
Figure 12.6 - NMEA Display page
Page 85