Trip Log; Using The Trip Log; Setup / Reset - Standard Horizon CP190i Owner's Manual

Gps chart plotters/fish finder
Hide thumbs Also See for CP190i:
Table of Contents

Advertisement

STEP UNIT
Allowable selection are Distance or Time
DISTANCE
User adjustable Distance interval of when Track point is laid down on the Chart page.
TIME
User adjustable Time interval of when Track point is laid down on the Chart page.
10.1

TRIP LOG

10.1.0 Using the Trip Log

On the Chart, Navigation, Highway and NMEA Data pages the windows may be customized
to show Trip Log information.
1. Select one of the pages listed above, press and hold [MENU]. You will notice one of the
data boxes will be highlighted.
2. Press [ENT] and move the ShuttlePoint knob to highlight TLOG, press [ENT] or move
the ShuttlePoint knob to the right.
3. A popup window will be shown with Nm (Nautical Mile), Sm (Statute Mile), Km
(Kilometer), Nm+Mt, Nm+Ft and RESET. Move the ShuttlePoint knob to select the
desired units of measure and press [ENT] or move the ShuttlePoint knob to the right.
4. Press [CLR] or move the ShuttlePoint knob to the right until the selected page (Chart,
Navigation, Highway or NMEA Data Page) is shown.

10.1.1 Setup / Reset

When Trip Log is selected in one of the data windows and you want to reset the log:
1. Press and hold [MENU] until a field is highlighted (it will be shown in a yellow frame).
2. Move the ShuttlePoint knob to highlight the Trip Log window TLOG and press [ENT].
3. A popup window will be shown. Move the ShuttlePoint knob to TLOG and press [ENT].
4. Another popup window will be shown. Move the ShuttlePoint knob to RESET and press
[ENT].
5. A warning popup window will be shown to confirm if you want to reset the Trip Log. Move
the ShuttlePoint knob to highlight YES and press [ENT]. The Trip Log is now reset.
6. Press [CLR] to store and exit the editing mode.
Page 74
Figure 10.1. 1 - Trip Log Reset
CP190i and CPF190i

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cpf190i

Table of Contents