Cpv550; Software Setup - Standard Horizon FF525 Installation And Operation Manual

2.4.4

CPV550

Switch
-
+
BATTERY
Red (no connection)
Black (no connection)
Green NMEA Common
Blue Port1 Input
Brown Port1 Output
Gray Port2 Input
White Port2 Output
Yellow Port3 Output
2.5

SOFTWARE SETUP

On software version v. 16.00.00R port 2 of the GPS Chart Plotter has be set to FF525 by default.
If the software in the GPS Chart Plotter is earlier than v. 16.00.00R, follow the steps below.
After connections have been made, the GPS Chart Plotter must be setup to communicate
with the FF525. Port 2 of the NMEA In/Out Communication Setup menu must be changed
to FISH FINDER as shown below for communications.
1. From the Chart page, press [MENU]. Move the ShuttlePoint knob to highlight SETUP
MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT 2 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select FISH FINDER and press [ENT] or move
the ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
Page 14
Fuse
Red
Black
I/O
FF525 Fish Finder
Note:
Gray and White wires should not be connected
to other devices when the FF525 is connected.
NOTE
1 RAM 2
AUX GPS VIDEO 1
Accessory cable
VIDEO 2
FF525