Routes; Creating A Route Using Waypoints - Standard Horizon CPV550 Owner's Manual

10. ROUTES

The GPS Chart Plotter has the capability to store 50 Routes with a maximum of 50
Waypoints each.
A Route can consist of Waypoints or Marks. The difference is when a Route is made using
Waypoints and the Route is deleted the Waypoints are also deleted. However if a Route is
made of Marks and the Route is deleted the Marks stay in memory.
10.0

CREATING A ROUTE USING WAYPOINTS

1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint
in the Route.
2. Press [RTE], you will notice the Starting Waypoint
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg
4. Press [RTE]. You will notice another Waypoint is shown under the cursor and a line joins
the starting Waypoint to the Second Waypoint.
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the remaining steps.
6. To name the Route press [MENU]. Move the ShuttlePoint knob to highlight USER
POINTS and press [ENT].
7. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
8. Move the ShuttlePoint knob to highlight REPORT and press [ENT].
9. Move the ShuttlePoint knob to highlight NAME and press [ENT]. A popup window will
be shown.
10. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Routes Name.
CPV550
Figure 10.0 - Creating a Route using Waypoints
NOTE
will be placed under the cursor.
in the Route.
Page 55