Routes; Creating A Route Using Waypoints - Standard Horizon CP180 Owner's Manual

9.

ROUTES

The CP180/CP180i and the CP300/CP300i have the capability to store 50 Routes with 100
Waypoints or Marks in each Route. A Route can consist of Waypoints or Marks. The
difference is when a Route is made using Waypoints and the Route is deleted the Waypoints
are also deleted. However if a Route is made of Marks and the Route is deleted the Marks
stay in memory.
Figure 9 - Example to show how the plotter switches from one Waypoint to another
9.0

CREATING A ROUTE USING WAYPOINTS

1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the starting Waypoint
in the Route.
2. Press [ROUTE], you will notice the starting Waypoint
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg
4. Press [ROUTE]. You will notice another Waypoint is shown under the cursor and a line
joins the starting Waypoint to the Second Waypoint.
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the next steps.
Page 66
Figure 9.0 - Creating a Route using Waypoints
NOTE
will be placed under the cursor.
in the Route.
GPS Chart Plotters