Selecting An Item; Chart Plotter Controls; Keys - Standard Horizon CPN700i Owner's Manual

Plotter is computing something. You can choose to wait until done or tap on
display to exit.
1.2.3

SELECTING AN ITEM

To select and activate a desired item:
· Tap your finger on the display over the item
or
· Move the ShuttlePoint knob up/down to place cursor on the item and then press the
ShuttlePoint knob to enter (if enabled, see ShuttlePoint Enter item in the Par. 2.1.4
"Settings in General Setup Menu")
or
· Move the rotary knob left/right to place cursor on the item and then press the
knob to enter
Refer to the following example:
A. Tap on DISPLAY COLOR. A popup window will be shown with the available options.
To set Normal palette tap on Normal.
or
B. Move the ShuttlePoint knob up/down to highlight DISPLAY COLOR and press the
ShuttlePoint knob to enter. A popup window will be shown with the available options.
To set Normal palette move the
press the ShuttlePoint knob to enter.
or
C. Move the rotary knob left/right to highlight DISPLAY COLOR and press the
knob to enter. A popup window will be shown with the available options. To set Normal
palette move the
to enter.

1.3 CHART PLOTTER CONTROLS

1.3.1

KEYS

The CPN700i and CPN1010i in addition to being able to control functions with the touch
display, also have dedicated keys and knobs provided for your convenience. You will notice
when a key is pressed a single beep will be produced which means the key press is valid.
When a key press is not valid the CPN Series Chart Plotter will produce 2 beeps.
Page 20
ShuttlePoint knob up/down to highlight Normal and
rotary knob left/right to highlight Normal and press the
on the
rotary
rotary
rotary knob
Owner's Manual