Getting Started; Mounting The Gps Chart Plotter; Bracket Mounting; Flush Mounting - Standard Horizon CP500 Owner's Manual

2. GETTING STARTED

Through this manual you will see highlighted words. Please refer to the legend below:
[MENU] If you see brackets around a bold and capital letter word this refers to a key press.
If you see brackets around a bold and small capital letter word this refers to a Soft Key
[C ]
HART
press.
GENERAL SETUP When a word(s) is bold capital letters and underlined, this refers to a menu selection
item.
2.0

MOUNTING THE GPS CHART PLOTTER

The CP500 is supplied with hardware for bracket or flush mounting. Below are pictures
showing actual examples of the two types of installation.
BRACKET Mount
2.1

BRACKET MOUNTING

Before installing ensure the area the bracket is mounted to is strong enough to support the
weight of the GPS Chart Plotter especially while under way. After the location is found,
attach the mounting base to the area using the supplied hardware.
2.2

FLUSH MOUNTING

The CP500 is supplied with a flush mount template for the cutout hole and screw holes
required to install the GPS Chart Plotter.
Before drilling holes make sure there is enough room to mount the GPS Chart Plotter and there
are no obstructions.
Page 12
NOTE
FLUSH Mount
CP500