Power Connections; Gps Chart Plotter Connections; Tee Cable - Standard Horizon FF525 Installation And Operation Manual

2.2

POWER CONNECTIONS

The installation of a switch is necessary to turn On or Off the FF525. Standard Horizon
recommends connecting the FF525 and GPS Chart Plotter to the same power switch (not
supplied) and fused source as shown in the following images below. Normally spare rocker
switch on a dash is used.
2.3

GPS CHART PLOTTER CONNECTIONS

The FF525 is connected to Standard Horizon GPS Chart Plotters via the TEE Cable. Refer
to the following images below.
2.4

TEE CABLE

If the Tee cable connector is too large to route through your boat, the FF525 can be opened
to remove the cable for easier routing. Also if the Tee cable is not long enough cable can
also be added.
Before following the steps below, disconnect 12VDC from the FF525.
1. Open the FF525 box by unscrewing the four screws.
2. Once the screws are removed, pull out the panel and the Printed Circuit Board (PCB).
3. Losen and remove the Green, White and Gray wires from the terminal strip.
4. Then lossen the cap and pull the wires from the inside of the FF525.
5. Route the Tee cable as need through the vessel and or add additional cable if needed.
6. If the cap was removed, insert it onto the Tee cable, then insert the cable into the FF525.
7. Reinstall the wires into the terminal strip. From left to right with the wires are Gray, White
and Green.
8. Tighten the cap to hold the Tee cable in place.
9. Push the panel towards the case (be sure to have the rubber gasket positioned
correctly).
10. Close the FF525 box by reinstalling the four screws.
Page 10
Figure 2.4 - Removing Power and Tee cables
WARNING
FF525