Error Messages In Gp-Gl Command Mode - GRAPHTEC CE6000 Series Service Manual

9.4

Error Messages in GP-GL Command Mode

Error LCD Display
Code
E02001
E02004
E02005
E02006
CE6000-UM-251-9370
Cause
The plotter received an
unrecognizable
Noise came in when the computer
was turned on.
The software configuration
regarding the output device has
been changed.
The plotter's interface conditions
have changed.
A command was received
containing numeric parameters
that exceed that command's
permissible range.
The software configuration
regarding the output device has
been changed.
The plotter's interface conditions
have changed.
An error occurred in the receipt of
data within the interface.
The software configuration
regarding the output device has
been changed.
The plotter's interface conditions
have changed.
The data out of cutting range has
been received.
9-4
9 TROUBLESHOOTING
Solution
Press the [ENTER] key.
Configure to drive the plotter from
the menu of the software.
Reset the interface settings of the
plotter.
Reset the interface settings of the
plotter.
Configure to drive the plotter from
the menu of the software.
Reset the interface settings of the
software.
Reset the interface settings of the
plotter.
Configure to drive the plotter from
the menu of the software.
Reset the interface settings of the
software.
Reset the interface settings of the
plotter.
Check the data.
Check the size of media and the
cutting range.
Check the magnification setting.
Check the step size settings.