Prepare The Power Cords - Sun Oracle Netra SPARC T3-1 Installation Manual

Related Information
PCIe card documentation
■

▼ Prepare the Power Cords

Prepare the power cords by routing them from the power source to the server.
Caution – Do not attach power cables to the power supplies until you have first
connect the server to a serial terminal or a terminal emulator (PC or workstation).
Note – The server goes into Standby mode and the ILOM service processor
initializes as soon as a power cable connects a power supply to an external power
source. System messages might be lost after 60 seconds if a terminal or terminal
emulator is not connected to the SER MGT port before power is applied.
Note – ILOM will signal a fault if both power supplies are not cabled at the same
time, since that situation will be a nonredundant condition.
1. Ensure that the +circuit breakers are off on the AC power source or that the DC
input cables are de-energized with no DC power present.
2. Route the power cords from the power source to the rear of the server and
secure the cables with nylon tie wraps.
Related Information
AC power source documentation
■
70 Netra SPARC T3-1 Server Installation Guide • August 2013