Sun Oracle Netra SPARC T3-1 Installation Manual page 88

2. Connect an Ethernet cable between one of the server's NET ports and the
network to which the server will communicate.
See
3. Plug the power cords into the power supplies and into a power source.
Note – Only two power connections are required for operation. Use four power
connections and two separate circuits for redundancy.
The service processor runs on the 3.3V standby voltage. As soon as power is
connected to the server, the service processor powers on, runs diagnostics, and
initializes the ILOM firmware.
After a few minutes, the SP login prompt appears on the terminal device. The host
is not initialized or powered on yet.
4. At the terminal device, log in to the SP as root with a password of changeme.
ORACLESP-xxxxxxxxxx login: root
Password: changeme
Oracle(R) Integrated Lights Out Manager
Version 3.0.12.x.x xxxxxx
Copyright (c) 2010, Oracle and/or its affiliates. All rights
reserved.
. . .
->
After a brief delay, the SP prompt is displayed (->). At this point, there are many
commands you can perform using the ILOM interface.
Additional SP information, such as how to change the password and how to set
up the SP network parameters is available in the online documentation set.
5. Open a second terminal device, log in to the SP as root with a password of
changeme.
After a brief delay, the SP prompt is displayed (->). At this point, there are many
commands you can perform using the ILOM interface.
80 Netra SPARC T3-1 Server Installation Guide • August 2013
"Back Panel Connectors and Ports" on page 66 for port information.)