Sun Oracle Netra SPARC T3-1 Installation Manual page 89

6. In the first terminal device, redirect the host output to display on the serial
terminal device:
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started. To stop, type #.
. . .
After you start the SP console, the server initialization takes approximately 20
minutes to complete. This terminal device displays all SP console messages during
initial boot.
7. In the second terminal device, power on the server:
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
This terminal device displays all system console messages during initial boot.
8. When prompted, follow the onscreen instructions for configuring the Oracle
Solaris OS on your host and enter the following configuration information.
You are prompted to confirm the configuration several times, enabling
confirmation and changes. If you are not sure how to respond to a particular
value, you can accept the default, and make future changes when the Oracle
Solaris OS is running. See
page 82 for a description of the Oracle Solaris OS parameters you must provide
during initial configuration.
9. Log in to the server and explore its capabilities.
You can use several commands to verify the functionality of the server. The
following list describes a few of them:
showrev – Displays the host name and server architecture information. Use the
■
-a option with this command to see the patches that are installed.
psrinfo – Displays information about the number and status of the processors
■
and cores in the host.
prtdiag – Displays server configuration and diagnostic information.
■
Review the Oracle Solaris OS man pages and documentation for more details.
"Oracle Solaris OS Configuration Parameters" on
Powering On the Server for the First Time 81