Advanced Optical Alignment - Christie J Series User Manual

Section 2: Installation and Setup

2.2.7 Advanced Optical Alignment

Boresight Alignment Procedure for CT Lens Mount
To adjust the boresight on a J Series projector equipped with a CT lens mount, see the Boresight Adjustment
Procedure instruction sheet found on the Christie website P/N: 013-100141-04.
Boresight Alignment Procedure for ILS Lens Mount
1. Display the Boresight Test Pattern by pressing the T
keypad and press the soft key that displays Test on the LCD display, then U
Boresight, then Enter, see
2. Focus the image on cross-hair pattern I. Evaluate the focus on cross-hair image II and III. If all 3 images
are in focus, no further action is required. If boresight is required see step 3.
3. If boresight is required, refer to
affect the corresponding cross-hairs on the test pattern.
a plastic cap, remove and retain before adjusting.
4. Use a 5mm Allen™ key to loosen the 3 locking setscrews on the lens mount, see
NOTE: The setscrews must be backed out several turns, so that they do not contact the inner lens mount
plate.
2-18
Figure 2-14.
F 2-14 B
IGURE ORESIGHT
Figure 2-15 to understand how the adjustment screws on the lens mount
EST
key on the remote keypad or use the built-in
P
ATTERN
NOTE: The cap screw,
J Series 1000W and 1200W User Manual
A K
P RROW EY
to cycle to
(Figure 2-16) may be under
Figure 2-16, below.
020-100706-02 Rev. 1 (03-2014)