Advanced Optical Alignment - Christie Roadster S+14K-J User Manual

4. If necessary, center the image on the screen: If the projector is mounted off center to the screen axis,
then offset the lens as much as required. Aim the projector over slightly towards the center of the screen,
but use caution when doing so, as too much tilt will cause excessive keystone distortion. Lens offset will
not.
5. Re-check side-to-side leveling: With the framing pattern on screen, double-check projector leveling so
the top edge of the image is parallel to the top edge of the screen.
6. Throw Distance: Ensure the projector is positioned in the throw distance range for the particular lens.
Folded Optics
In rear screen applications where space behind the projector is limited, a mirror may be used to fold the optical
path, see Figure 2-32 Folded Optical Path
considering this type of installation call your dealer for assistance.

2.3.5 Advanced Optical Alignment

Boresight Alignment Procedure
1. Display the Boresight Test Pattern by pressing the T
keypad and press the soft key that displays Test on the LCD display, then U
Boresight, then Enter, see
2. Focus the image on cross-hair pattern I. Evaluate the focus on cross-hair image II and III. If all 3 images
are in focus, no further action is required. If boresight is required see step 3.
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)
. The position of the projector and mirror must be accurately set - if
F 2-32 F
IGURE OLDED
Figure 2-33 .
F 2-33
IGURE
Section 2: Installation and Setup
O P
PTICAL ATH
key on the remote keypad or use the built-in
EST
A K
to cycle to
P RROW EY
2-27