Image Settings Menu - Christie J Series User Manual

Section 3: Operation
BLANKING (TOP, BOTTOM, LEFT, and RIGHT)
Crop the image so that unwanted edges are removed from the
display (changed to black). Blanking defines the size of the
Active Input Window, or area of interest. Range of adjustment
depends on the source resolution and other factors.
NOTE: Blanking a PIP image resembles zoom. For
example, left Blanking zooms the right side of the PIP
image; Right Blanking zooms the left side. There are no
black bars.
PIP Blanking
Active Input Window 720x483
1. Top Blank
Bottom Blank
2.
3. Left Blank
4. Right Blank
3.7

Image Settings Menu

Use the Image Settings menu to alter your main
image without affecting its size or position.
Changes made are applied immediately and are
saved when you exit the menu (press E
M
ENU
). Options not available for the projector
model or source are disabled and appear dim
(grey).
CONTRAST
"Contrast" increases or decreases the perceived difference between light and dark areas of your image (0-100).
For best results, keep close to 50. For best results, start with a low value and increase so that whites remain
bright but are not distorted or tinted, and that light areas do not become white.
lighting changes, an adjustment of Gamma is recommended (see below).
3-22
0
0
0
0
F 3-26 B
IGURE LANKING OF A
XIT
or
F 3-25 B
IGURE LANKING OF A
PIP Blanking
Active Input Window 720x483
1. Top Blank 0
Bottom Blank 0
2.
3. Left Blank 30
4. Right Blank 0
PIP I
MAGE
NOTE:
J Series 1000W and 1200W User Manual
P I
RIMARY MAGE
If the environment
020-100706-02 Rev. 1 (03-2014)