Christie J Series User Manual page 91

4. When adjustment of the corners is complete, select OK.
that the projector is "Processing request". The settings are applied to the displayed image, and will take
approximately 10 seconds. If Vertical Keystone adjustments have been made, starting to do any Horizontal
Keystone adjustments will erase the Vertical settings, and vice versa.
5. After the Horizontal or Vertical adjustments have been made, selecting 2D Keystone adjustments will
retain these settings. Fine adjustment can now be made by moving any single corner separately.
6. Use the arrow keys to move to the required corner.
7. Press E
NTER
8. Use the arrow keys to move the selected corner to match the screen.
9. Press E
NTER
10. Repeat Steps 6 to 9 to adjust all 4 corners until they match the screen.
11. Select OK to apply the new corner positions to the image.
approximately 10 seconds indicating that the projector is "Processing request".
Under certain combinations of extreme keystone co-ordinates and specific signal frequency, a keystoned image
may result that is outside the bandwidth limitations of the projector. When attempting to apply the keystone
settings, a message will pop up on the OSD, indicating that the bandwidth has been exceeded and the keystone
cannot be applied. The cursor co-ordinates for keystone adjustment will remain at the failed keystone position.
This will allow the user to make minor changes and attempt to reapply the corner settings. Either the co-
ordinates must be adjusted, or the free run frequency must be changed to fall within the allowed bandwidth.
The F
UNC ELP
+H
Blending and Black Level Blending features. This is helpful when, in some extreme keystone configurations,
some image corruption may appear and/or the menus may not be readable. Although F
these features, it will not overwrite their settings. If keystone is simply enabled again, the same image
corruption may occur. After pressing F
which will set all keystone co-ordinates to zero.
BRIGHTNESS UNIFORMITY - Submenu
• Brightness Uniformity provides further refinement of displays already matched for their primary colors and
overall light output. Use Brightness Uniformity to create an exceptionally smooth image in which no area
appears brighter than another. In the Brightness Uniformity menu, enable the Brightness Uniformity Enable
check box to access a multitude of adjustments for light output control in specific areas throughout the
image. Your settings apply as long as the Brightness Uniformity Enable check box is enabled. While making
adjustments, enable the Coarse Adjustment check box to apply Brightness Uniformity settings with a large
granularity. Coarse Adjustment helps identify brightness changes and accelerates projector response time
while adjusting settings. To disable the Brightness Uniformity function, delete the Brightness Uniformity
Enable checkmark.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
NOTE:
to select the corner.
again, to save that position for the corner.
key combination will immediately disable the Keystone, Brightness Uniformity, Edge
UNC
NOTE:
NOTE: The current corner will be displayed in red.
The current corner will be displayed in green.
NOTE:
, it is recommend to immediately "Reset Keystone Settings",
ELP
+H
Section 3: Operation
A message will be displayed indicating
A message will be displayed for
UNC
+H
ELP
disables
3-41