Christie J Series User Manual page 22
J series 1000w & 1200w projector
Hide thumbs
Also See for J Series:
- User manual (176 pages) ,
- Service manual (96 pages) ,
- Setup manual (60 pages)
Table of Contents
Advertisement
Section 2: Installation and Setup
Adjustable Feet
Located on the underside of the projector are two adjustable feet. Raise or lower these feet when positioning
the projector to ensure it is level on all sides so the displayed image will appear rectangular without any
keystone.
Refer to
2.2.5
for instructions on how to adjust the feet of the projector.
Input Panel
All source connections are made to the input panel located at the back of the projector. Any of the available
optional input cards can be installed in the 4 option card slots. The slots are labeled 1 through 4. All option
cards have LEDs to indicate their status.
Cooling and Air Vents
Adequate airflow through the projector will prevent it from overheating. Keep all projector vents unobstructed
and ensure adequate airflow around the projector. See
Lamp Door
The lamp door is located at the rear of the projector to provide easy access to the lamp module for replacement.
Refer to
5.1.1 Lamp and Filter
lamp off when the door is opened.
2-6
Figure
Allow at least a half meter or more
of space between the projector and
a wall or other structure and place
it on a platform that does not extend
past the exhaust vents.
F
2-6
IGURE
Replacement. The lamp door is fitted with a safety interlock which switches the
2-6.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Advertisement
Table of Contents
