Replacing The Projection Lens - Christie J Series User Manual

5.2

Replacing the Projection Lens

IMPORTANT!
1. Rotate the lens clamp to the OPEN position, to remove old lens. See
2. Align the new lens interface plate with the lens mount. Align the lens electrical connector with the mating
connector on the lens mount. Fully insert the assembly straight into the lens mount opening without
turning. Press using your hand as shown in
as this can cause damage.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Remove the rear lens cap from the new lens. Keep the front lens cap on the lens to protect it
during installation.
F 5-6
IGURE
Figure 5-7. NOTE: Ensure the lens is not inserted at an angle,
LARGE LENS CAP
Section 5: Maintenance
Figure 5-6.
5-5