Christie J Series User Manual page 120

Section 4: Web User Interface
T A S
O DD A CHEDULED
1. Click Add to open the RTE Wizard.
2. Select the Scheduled Event tab.
3. Select the frequency option for the event by selecting either Once, Daily, Weekly, or Monthly.
End Date is enabled when Daily, Weekly or Monthly repeat options are selected.
4. Click within the Start Time field to open a calendar pop-up window.
5. Navigate to and choose a desired date. The selected date will populate the Start Time field.
6. In the field below the Start Time field, enter a start time in the format "hr:min:sec". The default is the
current time.
7. Click Sync to set the computer and projector time to be the same; otherwise, the event will run based on
the projector time.
8. Enter a description of the scheduled event in the Description field.
9. Enter a serial command or a sequence of serial commands, with which you wish the projector to perform in
the Command String box.
• If a GPIO command string is needed, click the GPIO Output Helper button for instructions on how to
create the command structure.
pins on the GPIO connector. Pin 1 = +12V and Pin 5 = Ground. These are not included.
block toggles between H, L, and X.
pulse high or low. See
• NOTE : Serial Representation box is read only.
• Click the Help button for a description of special RTE commands available for adding loops and delays
to the command sequence.
4-10
E
VENT
NOTE: The scheduled tab is always selected by default on add.
F 4-14 S
IGURE CHEDULED
NOTE: Synching the projector time to be that of your system time.
NOTES: 1)
3) If the Pulse check box is selected, those I/O Pins defined will
Figure 4-15 GPIO Output
F 4-15 GPIO O
IGURE
E W
VENT INDOW
NOTE:
The Output field contains 7 blocks which refer to the 7 I/O
Helper. See Appendix B:
H
UTPUT ELPER
Maximum of 100 characters.
2) Clicking a
for detailed information.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 03-2014
NOTE: