Advanced Optical Alignment - Christie 1000W J Series Setup Manual

Section 2: Installation and Setup
4. If necessary, center the image on the screen: If the projector is mounted off center to the screen axis,
then offset the lens as much as required. Aim the projector over slightly towards the center of the screen,
but use caution when doing so, as too much tilt will cause excessive keystone distortion. Lens offset will
not.
5. Re-check side-to-side leveling: With the framing pattern on screen, double-check projector leveling so the
top edge of the image is parallel to the top edge of the screen.
6. Throw Distance: Ensure the projector is positioned in the throw distance range for the particular lens.
Folded Optics
In rear screen applications where space behind the projector is limited, a mirror may be used to fold the optical
path, see Figure 2-5
of installation call your dealer for assistance.

2.2.3 Advanced Optical Alignment

Boresight Alignment Procedure
1. Display the Boresight Test Pattern by pressing the T
keypad and press the soft key that displays Test on the LCD display, then U
Boresight, then Enter, see
2-6
. The position of the projector and mirror must be accurately set - if considering this type
Figure 2-6 .
F 2-5
IGURE
EST
key on the remote keypad or use the built-in
F 2-6
IGURE
A K
P RROW EY
to cycle to
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)