Christie J Series User Manual page 127

4. RELEASE THE LAMP LOCK
Pull out and turn the lamp lock lever, which is located to the left of the lamp module, turn it 1/4 turn counter
clockwise to the "unlock" position. See
5. REMOVE THE LAMP MODULE
Firmly grasp the lamp by its housing only and pull it straight out (lamp slides along guides) until it is free. See
Figure 5-3. Discard the lamp using safe disposal/recycling practices.
6. RECORD THE SERIAL NUMBER OF THE NEW LAMP
7. INSERT THE NEW LAMP MODULE
Align the new lamp with the top and bottom guides on the left side of the lamp compartment. See
Slide the lamp into the terminal block.
seated.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Figure 5-2.
F 5-2
IGURE
F 5-3
IGURE
NOTE: A slightly harder push may be required to ensure it is fully
F 5-4
IGURE
Section 5: Maintenance
Figure 5-4.
5-3