Adjusting The Image - Christie J Series User Manual

If desired, review and/or edit the following channel setups in the Channel Edit menu:
• NAME
An alphanumeric label can be defined and/or changed here. Channel names can be up to 12 characters in
length. The default name is the horizontal and vertical sync frequencies.
• CHANNEL
A two-digit channel number can be changed here.
exists, a dialog message appears indicating that this number is already in use–assign a different channel
number. 2) You can define up to 99 channels.
• SLOT
1-4, corresponding to which slot of the projector input panel that the source is connected:
• INPUT
1-6, corresponding to which input on the selected slot the source is connected to.
• IN MENU
If checked (default, except for automatically defined channels with unchanged parameters), this defined
channel will then appear in the list available when C
be accessed via C
channel list is an option that must be set in the Menu Preferences menu.
• AUTO SELECT
If checked, (default), the projector can automatically locate this channel when an incoming input signal
matches. If not checked, the projector can locate the selected channel only when it is directly selected via
C
HANNEL
on the keypad—and a change in input signal will not result in a channel change.LOCKED
If checked, all of the image settings for this channel are locked. If unchecked (default), all available image
settings can be adjusted as desired. You cannot use Auto Setup with a locked channel.
• PREVIOUS CHANNEL
Select this option to see or change Channel Edit settings for the previous channel in the Channel Setup list.
• NEXT CHANNEL
Select this option to see or change Channel Edit settings for the next channel in the Channel Setup list.
3.5

Adjusting the Image

The most commonly used options for image adjustments are accessed through two menus: Size and Position
ENU
(M 1) and Image Settings (M
menus, you can change settings affecting the image from the current channel by working with the appropriate
slide bars, check boxes and pull-down lists. E
from the Main menu) and accept any changes you may have entered. Settings are saved with the current
channel.
From your presentation, you can access any of the individual options in these menus by pressing M
followed by the appropriate two-digit number representing their location in the menu system. For example,
press M
ENU
24 to quickly access the "Color Space" option in the Image Settings menu.
NOTES: 1) For certain options, preference may be to use a "direct key" from presentation level to go directly
to a particular option without traveling through the menu system (available for certain display parameters
only). For example, press C
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
HANNEL
on the keypad or via the Auto Source function.
ENU
2), both of which appear in the Main menu. From either of these two
to access the "contrast" slide bar immediately. Press E
ONTRAST
NOTES: 1) If you enter a channel number that already
HANNEL
key is pressed. If unchecked, the channel must
XIT
will return to the previous menu (or to the presentation, if
Section 3: Operation
NOTE:
On-screen display of the
ENU
XIT
to return to
3-17