2: Installation And Setup; Projector Quick Setup And Installation - Christie J Series User Manual

2 Installation and Setup
This section explains how to install, connect and optimize the projector for delivery of superior image
quality. Illustrations are graphical representations only and are provided to enhance the understanding of
the written material.
2.1

Projector Quick Setup and Installation

The following instructions are for those preferring a quick setup. Refer to the remaining subsections for
detailed setup instructions.
WARNING
WARNING
STEP 1 - Installing a Projection Lens
The projection lens, shipped separately from the projector, must be installed prior to setting up the projector.
WARNING
IMPORTANT!
LENS INSTALLATION
IMPORTANT!
1. Rotate the lens clamp to the OPEN position, see
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Always power down the projector and disconnect all power sources before servicing or
cleaning.
Refer to Safety Warnings and Guidelines in
Remove the lens plug from the lens opening in the projector before installing the lens.
Retain the lens plug for projector transportation to protect the optical components
from dust and debris.
The lens seals the projector, preventing contaminants from entering the interior of the
projector. Never operate a projector without a lens.
Remove the rear lens cap from the lens. Keep the front lens cap on the lens to protect it
during installation.
Section 5
Figure 2-1.
F 2-1
IGURE
Maintenance.
2-1