Christie J Series User Manual page 44

Section 2: Installation and Setup
Analog BNC Input Card
This card accepts several types of sync modes. In 5-wire sync mode all 5 BNC connectors are used. If H and V
connectors are swapped, this card will still operate normally. An analog graphic source such as a VGA from a
PC can be connected. The card can operate in 4-wire sync mode, which accommodates 4-wire RGBC sources.
The composite sync cable can be connected to either the H/C BNC or the V BNC. The card supports 3-wire
RGB or YPBPr sync modes, sometimes called sync-on-Green (SOG). In this mode the H/C and V connectors
are not used. The sync is connected to the Green/Y BNC connector. This card offers no loop out capability.
There are 2 LEDs on the module faceplate. PWR indicates power has been applied and the card is initialized,
signal indicates a valid signal has been detected.
Dual 3G/HD/SD - SDI Input Card
This card accepts both standard-definition (SD) and high-definition (HD) serial-digital-interface (SDI) signals
from 1 of 2 standard-definition (SD) or high-definition (HD)3GHz SDI sources. Both single-link HD and dual-
link HD signals are accepted. The card has two SD/HD-SDI outputs, each of which is "loop through" for its
respective input. There are 3 LEDs on the module faceplate. PWR indicates power has been applied and the
card is initialized, and the two signal LEDs indicate a valid signal has been detected on the respective input.
Dual Link DVI Input Card
This card accepts a single DVI signal with or without High-Bandwidth Digital Content Protection (HDCP)
video signal over a DVI-I connector and analog video signals over the DVI-I or 15-pin VGA connector. The
module can simultaneously support a digital signal on the DVI input and an analog signal on the VGA port or
an analog signal on the DVI input and an analog signal on the VGA port. There are 4 LEDs on the module
faceplate. PWR indicates power is applied and the card is initialized, and the other 3 on the right side of the
corresponding connectors indicate that a valid signal has been detected. With a suitable HDMI-to-DVI adaptor,
HDMI signals can be input to this card, except the audio will be lost.
2-28 J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)