Advanced Optical Alignment - Christie J Series 2.0 kW Setup Manual

Folded Optics
In rear screen applications where space behind the projector is
limited, a mirror may be used to fold the optical path. The
position of the projector and mirror must be accurately set - if
considering this type of installation call your dealer for
assistance.

2.2.3 Advanced Optical Alignment

Boresight Alignment Procedure for CT Lens Mount
To adjust the boresight on a J Series projector equipped with a CT lens mount, see the Boresight Adjustment
Procedure instruction sheet found on the Christie website (P/N: 013-100141-04).
Boresight Alignment Procedure for ILS Lens Mount
1. Display the Boresight Test Pattern by pressing the T
keypad and press the soft key that displays Test on the LCD display, then U
Boresight, then Enter.
2. Focus the image on cross-hair pattern I. Evaluate the focus on cross-hair image II and III. If all 3 images
are in focus, no further action is required. If boresight is required see step 3.
3. If boresight is required, refer to
on the lens mount affect the corresponding cross-hairs on the test pattern.
NOTE: The capscrew may be under a plastic cap, remove and retain before adjusting.
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-03 Rev. 1 (02-2014)
EST
Figure 2-1 Cross-Hair Pattern
Section 2: Installation and Setup
key on the remote keypad or use the built-in
A
P RROW
to understand how the adjustment screws
K
to cycle to
EY
2-7