Christie J Series User Manual page 126

Section 5: Maintenance
Table 5.1
Projector Part Number
DS+8K-J
Mirage DS+8K-J
HD7K-J
Mirage HD7K-J
Mirage WU7K-J
Matrix WU7K-J
DS+10K-J
HD9K-J
1. TURN THE LAMP OFF
Press the power to switch the lamp off. Allow the cooling fans to stop automatically (within 5 minutes) before
proceeding with step 2.
handling.
2. UNPLUG THE PROJECTOR
When the cooling fans have stopped, turn the main switch of the projector off, then unplug the projector.
WARNING
3. REMOVE THE LAMP DOOR
WARNING
Using a #2 Phillips screwdriver, loosen the two (2) lock screws securing the lamp door, which is located at the
rear of the projector below the Input panel. See
5-2
Projector Model
132-004105-XX
132-004127-XX
132-005106-XX
132-005128-XX
132-006129-XX
132-006130-XX
132-007108-XX
132-008109-XX
NOTE: This wait period is required to allow the lamp to sufficiently cool before
Always power down and unplug the projector prior to servicing. Allow the lamps to
cool before handling.
Protective gear required. Wear a face shield.
Lamp Type
1.0 kW
1.2 kW
Figure 5-1.
F 5-1
IGURE
Lamp/Filter Kit Required
003-120116-XX
003-120117-XX
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)