Christie J Series User Manual page 40

Section 2: Installation and Setup
ETHERNET NETWORK SETUP
to connect each projector Ethernet port to a hub belonging to the network. A controller or PC must also be
connected to the hub, see
via 802.11b/g.
SETTING THE PROJECTOR IP ADDRESS, SUBNET MASK AND GATEWAY
COMMUNICATIONS - Submenu.
ETHERNET / COMMUNICATION SETTING
default) or static.
CHANGING THE PORT#:
the projector be changed from its default of 3002. If so, enter a new port number in the Ethernet Settings menu
or include the new port#.
Separating Networks
By default, communications originating from one type of serial controller—RS-232 vs. RS-422 vs. Ethernet—
stay on the corresponding network path. A "Separate" setting indicates this separation for "Network Routing"
in the Communications menu, see
controller, for example, it will communicate only with the projector to which it is connected unless you change
this setting to either "RS-232 and RS-422 Joined" or "All Joined".
2-24
: To add one or more projectors to an Ethernet network, use standard CAT5 cable
NOTE:
Figure 2-23. A wireless router can be used to communicate to the projectors
F
IGURE
: Includes settings for configuring the IP address via HDCP (factory
On some Ethernet networks, firewall restrictions may require that the port number of
Section 3.8.7 COMMUNICATIONS -
2-23
: See Section 3.8.7
Submenu. If you are using an RS-422
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)