Advanced Optical Alignment - Christie Mirage M Series Setup Manual

Section 2: Installation and Setup

2.1.3 Advanced Optical Alignment

Boresight Alignment Procedure
1. Display the Boresight Test Pattern by pressing the T
keypad and press the soft key that displays Test on the LCD display, then U
Boresight, then Enter, see
2. Focus the image on cross-hair pattern I. Evaluate the focus on cross-hair image II and III. If all 3 images
are in focus, no further action is required. If boresight is required see step 3.
3. If boresight is required, refer to
affect the corresponding cross-hairs on the test pattern.
plastic cap, remove and retain before adjusting.
4. Use a 5mm Allen™ key to loosen the 3 locking setscrews on the lens mount, see
The setscrews must be backed out several turns, so that they do not contact the inner lens mount plate.
2-6
Figure 2-7.
F 2-7 B
IGURE ORESIGHT
Figure 2-8 to understand how the adjustment screws on the lens mount
key on the remote keypad or use the built-in
EST
P
P
ATTERN
The capscrew,
NOTE:
A K
to cycle to
RROW EY
(Figure 2-9) may be under a
Figure 2-9, below.
NOTE:
Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)