STEP 6 - Selecting a Source
Press one of the input keys on the remote or built-in keypad to select and display the image for the source you
connected in Step 3.
STEP 7- Adjusting Image
Adjust the image settings, such as Brightness, Contrast, Gamma, Focus, Zoom, etc. using the direct keys on the
remote or built in keypad.
2.2
Detailed Setup and Installation
DANGER
WARNING
2.2.1 About the Projector
Built-in Keypad
The built-in keypad is located on the rear of the projector. Use it similarly to the IR remote to control the
projector. An LCD display is located above the keypad for displaying projector status.
AC Receptacle
The AC receptacle is located at the back of the projector. Use this receptacle to plug in an appropriately rated
line cord.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
NOTE:
Refer to
Always power down the projector and disconnect all power sources before servicing
or cleaning.
Refer to Safety Warnings and Guidelines in
F
IGURE
Section 3 Operation
for more details.
1.4 Safety Warnings and Guidelines
2-5 R
O
EAR
RIENTATION
Section 2: Installation and Setup
.
2-5