Connecting Sources - Christie J Series User Manual

2.3

Connecting Sources

Sources are connected to the Input Panel located at the back of the projector.
Input Panel allows one image processor board and up to 4 input cards to be inserted. The input cards are hot
swappable i.e. they may be plugged in and out while the projector is running. The image processor should only
be replaced when the projector is off or when it is in standby mode.
There are seven option Input cards available:
• High-Definition Multimedia Interface/Twin HDMI (High-Definition Multimedia Interface)
• Analog BNC
• Dual 3G/HD/SD-SDI (Serial Digital Interface)
• Dual Link DVI
• Video Decoder
• DMX512 Interface
• Twin DisplayPort Input
These cards slide into the option slots, shown in
slot. One or more of the option slots may be used with any combination of option cards, including multiples of
the same card type. There may be up to 2 active inputs being displayed at any time, either from one card or
from 2 cards. These 2 inputs can be routed to outputs or to the main or PIP video image.
Specifications for more details.
LEDS
LEDs are located on the faceplate of each input card and indicate the following:
• Power ON - Green
• Signal Valid - Green
• Signal Invalid - OFF
Twin HDMI Input Card
This card accepts one or two HDMI inputs, and can route one or both inputs to the outputs of the card. As a
factory default, the output label LED '1-OUT' loops out the main image being displayed on the projector. The
output labelled '2-OUT' loops out the image displayed in the picture in picture (PIP). Alternatively, a direct
loop can be enabled (HDMI Input 1 single loops to HDMI Output 1, and HDMI Input 2 loops to HDMI output
2). Refer to 3.10 Input Switching & PIP Menu
looped out of this card. There are 5 LEDs on the module faceplate. The PWR on the left side indicates power is
applied, and that the card is initialized. The LEDs to the right side of the corresponding connectors indicate
that a valid signal is detected. In the case of the output, the LED indicates a signal is currently being looped
out.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Figure 2-25 Input Panel. The option cards can be used in any
for details. Any input from any optional input card can be
Section 2: Installation and Setup
Figure 2-25 Input Panel. The
NOTE: See Section 7
2-27