Advanced Optical Alignment - Christie Mirage M Series User Manual

Section 2: Installation and Setup

2.2.6 Advanced Optical Alignment

Boresight Alignment Procedure
1. Display the Boresight Test Pattern by pressing the T
keypad and press the soft key that displays Test on the LCD display, then U
Boresight, then Enter, see
2. Focus the image on cross-hair pattern I. Evaluate the focus on cross-hair image II and III. If all 3 images
are in focus, no further action is required. If boresight is required see step 3.
3. If boresight is required, refer to
on the lens mount affect the corresponding cross-hairs on the test pattern.
14) may be under a plastic cap, remove and retain before adjusting.
4. Use a 5mm Allen™ key to loosen the 3 locking setscrews on the lens mount, see
Locations, below.
inner lens mount plate.
2-12
Figure 2-12 Boresight
F 2-12 B
IGURE
Figure 2-13 Cross-Hair Pattern
The setscrews must be backed out several turns, so that they do not contact the
NOTE:
key on the remote keypad or use the built-in
EST
Pattern.
P
ORESIGHT ATTERN
to understand how the adjustment screws
A K
to cycle to
P RROW EY
The capscrew, (Figure 2-
NOTE:
Figure 2-14 Screw
Mirage M Series User Manual
020-100575-02 Rev. 1 (11-2010)