Christie J Series User Manual page 41

Communicating to all Ports
To relay all messages to all ports—RS-232, RS-422, and Ethernet—set the "Network Routing" option in the
Communications menu for each projector to "All Joined", see
This configuration is useful if you are using a non-RS-232 controller with the RS-232 linking available
between these projectors. For example, you may want to use both an RS-422-compatible controller and an
Ethernet-connected PC for working with a network of projectors linked via their RS-232 in/out ports.
To isolate just RS-422 communications, select "RS-232 and Ethernet Joined". In
projector #1 will respond to the RS-422 controller.
To isolate just Ethernet communications, select "RS-232 and RS-422 Joined"—only projector #1 will respond
via Ethernet.
System Integration - GPIO Connector
The GPIO connector on the input panel interface
interfacing a wide range of external I/O devices. Refer to
configuration and how to program the GPIO.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
F 2-24
IGURE
Figure 2-20 Connecting
Appendix B:
F 2-25 I P
IGURE NPUT ANEL
Section 2: Installation and Setup
Section 3.8.7 COMMUNICATIONS -
Figure 2-25 Input
RS-422, provides a method of
for complete details on pin
Submenu.
Panel, only
2-25