Christie J Series User Manual page 104
J series 1000w & 1200w projector
Hide thumbs
Also See for J Series:
- User manual (176 pages) ,
- Service manual (96 pages) ,
- Setup manual (60 pages)
Table of Contents
Advertisement
Section 3: Operation
• PIP BORDER WIDTH
Specify how thick the Picture-In-Picture border should be. Setting the control to zero disables the border.
NOTE:
The thickness of the border is proportional to the size of the PIP image. Larger windows will have
larger borders.
• PIP BORDER COLOR
Select the color of the optional border around the Picture-In-Picture image.
PIP SIZE & POSITION - Submenu
Most controls in the PIP Size and Position menu adjust the PIP (secondary) image in the same fashion as their
counterparts in the main Size and Position menu.
• POSITION PRESETS
Set the location of the PIP (secondary) image in the display.
PIP IMAGE SETTINGS - Submenu
The controls adjust the PIP (secondary) image in the same fashion as their counter parts in the main Image
Settings menu.
FADE TIME
Sets the amount of time (in seconds) it takes to fade between images on a source switch and fades in the PIP
image.
FRAME LOCKING
When the selection is set to Frame Lock, output image frames are locked to the input. When locked, the
output is always locked to the primary input, never the secondary image. Select Free Run and this will set the
output to close to 60Hz for all sources.
AUTO INPUT SEARCHING
When enabled, the system will continually search for the next valid signal when no signal is present or when
loss of sync occurs on the current user selected input. In the case of multiple signals to choose from, the order
is based on slot, followed by inputs on that slot.
HDMI OUTPUT LOOP SOURCE
Configure the HDMI output options.
Select Direct Loop to directly pass-through the HDMI input signals (from the same Twin HDMI Input Card).
The Input1 signal is looped to Output1 and the Input2 is looped to Output2.
Select Main/Secondary Loop to loop the Main & secondary video to the outputs (regardless of which card
these signal originate from). The Main video signal is looped to Output1 and the Secondary video signal is
looped to Output2.
Select Disable to shut off the HDMI outputs completely.
3-54
NOTE:
Refer to
3.7 Image Settings Menu
for details of Contrast to Advanced Image Settings.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Advertisement
Table of Contents
