Christie J Series User Manual page 59

NOTES: 1) If there is no signal present, all source-dependent adjustments are disabled.
inactivity, the projector leaves the menu system and returns to the presentation.
only.
On-line Help
Press H to display summary information about the current menu or highlighted option. Press H
ELP
exit.
1.
Size & Position
2. Image Settings
3.
Channel Setup
4.
Configuration
5. Lamp
6.
Status
7.
Input Switching & PIP
8.
Test Pattern
9. Language
The Global Icon
Menu options that include this icon apply universally. Menu options without this icon apply to the
selected channel only, or are unsaved diagnostic settings.
Using Slide bars and Other Controls
Most of the function menus allow you to change settings by using slide bars, check boxes, and pull-down lists.
Navigating options:
• Enter the menu option number corresponding to the setting you wish to change (for example, press M
3 to select "Vertical Stretch" in the Size and Position menu).
• Move the highlight to the option desired and press E
• Move the highlight to the option desired and press L
• You can bypass the menus entirely and use a single key to immediately access an adjustment during your
presentation (applies only to options having their own key, such as Contrast, Brightness, Gamma, etc.).
• For "blind" access, hide the entire menu system (see OSD key, above) and access using the proper sequence
of key presses.
Slide bars in menus – The current value for a given parameter,
such as size or vertical stretch, appears to the left of its slide bar
icon (adjustment window). This number often expresses a
percentage, or it may have units associated with it (such as
pixels), depending on the specific option. Press L
A K
RROW EY
to gradually adjust the setting up or down—both the
number and the length of the bar change accordingly. Hold for continuous adjustment. Or press E
activate a slide bar text box for specific number entry via the keypad and then press E
E
XIT
to cancel).
"Direct" slide bars - For quick access, to Gamma, Brightness, and Contrast slide bars without traveling the
menu system. Press Gamma, Brightness, or Contrast to display the contrast slide bar.
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)
Main Menu
Help
Off
English
F
IGURE
Use this menu to adjust settings affecting current image
size and position, such as horizontal and vertical
placement, blanking, resizing, and others.
3-5 O -L H
N INE ELP
NTER
.
/R A
EFT IGHT RROW
1.
/R
F
EFT IGHT IGURE
Section 3: Operation
2) After 15 minutes of
3) The Status menu is read-
Help
K
EY
to adjust immediately.
White Uniformity
Left Side 35.6
3-6 E S
XAMPLE OF A
NTER
to save (or press
ELP
again to
1
ENU
B
LIDE AR
NTER
to
3-9